1·When joint is filled, a continuous rim of brazing alloy will be visible.
连接处被充满后，就会看到焊接合金的边缘。
2·The temperature of the joint should be hot enough to melt the brazing alloy .
连接部位的温度应该高到能够融化铜焊合金。
3·When joint is filled, a continuous run of solder or brazing alloy will be visible.
在安装连接部件时，可以看到焊料和钎焊合金继续流动。
4·High power transverse flow CO2 laser was used to scan the brazing alloy and diamond grits.
采用高功率横流CO2激光扫描钎料合金与金刚石颗粒。
5·The theoretical rules among the high temperature performance of the brazing alloy, strain rate an…
分析了钎料高温性能与应变速率、钴的变质剂作用等因素之间的理论规律。
6·The effect of copper on low boron low chromium nickel based brazing alloy was studied by experiments.
本文研究了铜对低硼、低铬镍基钎料工艺性能的影响。
7·The results show that the melting point of brazing alloy is constant when the content of boron and silicon is reduced and the right amount of copper is added in.
试验结果表明，在降低镍基钎料中硼、硅元素的同时加入适量的铜可以使钎料的熔点基本不变。
8·The product is used for brazing copper and copper alloy, easy processing, plastic, with good infiltration.
用于做钎焊铜及铜合金，易加工，塑性好，具有良好的浸润性。
9·Since brazing is performed at temperatures within the hot-short range, strain must be avoided during the brazing and cooling of this alloy.
由于钎焊是表现在温度与热短程，应变必须避免在钎焊和冷却这一合金。
10·Solder factory is mainly engaged in the production and marketing of products, aluminum copper alloy brazing flame or high-frequency brazing material.
本厂主要从事焊锡制品的生产和销售，铝铜合金的火焰钎焊或者高频钎焊材料。